Retrofitting Existing Spinkler with Drip

Go To HOME

Option 1-Threaded Bubblers and Emitters

Replace each sprinkler with pressure compensating drip bubblers or emitters and run 1/4” tubing from the riser to your plants. Single-outlet emitters allow you to run 1/4" drip tubing to individual plants. With a 6-outlet bubbler on top of a 1/2" riser, you can run up to 6 1/4" drip tubes from the bubbler.

The emitters and bubblers operate at 10 psi - 40 psi. Check your water pressure before installing. If your pressure is 40 psi or less, you are good to go. If not, you will need to install a pressure regulator.

Pressure Compensating Emitters

There are three emitters available: 1/2 gph (red inside), 1 gph (black inside), and 2 gph (green inside). The barbed tip accepts 1/4" drip micro tubing. To install, simply remove the sprinkler from the 1/2" threaded riser. You can screw the emitter directly onto the riser or add a Marlex elbow as described in the Quick Tip below.

QUICK TIP: Use a Marlex Elbow for 90 degree turn - To run the 1/4" tubing parallel to the ground rather than straight up off of the riser, use a Marlex Elbow. This allows the tubing to run flat on the ground and avoids a trip hazard.

Option 2- Micro Jet Sprayers

Replace sprinklers with drip micro spray fittings. Swap out the sprinkler with a micro spray adapter. The adapter will accept threaded micro spray fittings.

 Micro Spray Adapter 

The adapter threads directly onto a 1/2" riser. Micro jet fittings thread into the top.

Micro Jet/Spray fittings operate best between 10 psi - 30 psi. Check your water pressure before installing. If your pressure is 30 psi or less, you are good to go. If not, you will need to install a pressure regulator.

These spray fittings come in a variety of configurations from fixed patterns and outputs to adjustable spray and stream options.

Option 3- Cap Sprinklers & Add Drip Regulator to the Supply Line

Cap off all of the sprinklers and add a standard drip system with 1/2" drip tubing and drip emitters. You can leave your irrigation valve in place. Just add a drip regulator, filter and swivel adaptor to the existing PVC line. From there you can add drip mainline tubing and drippers or emitter tubing. Irrigation Direct carries a selection of adapter fittings (like the one shown) that will help with most connections.

An MH9 adapter elbow (with male hose threads) is glued onto 3/4" PVC pipe. The inline filter, drip regulator, and swivel adapter are then attached.

<<Previous Page

Ref 2020