Barbed Fittings For Micro Tubing
1/4” Barbed Connectors or Micro Connectors, Barbed Fittings: Drip irrigation barbed micro connectors are used to make connections between 1/4” drip irrigation micro tubing or to connect 1/4" drip irrigation micro tubing and 1/4" soaker hose irrigation dripline to 1/2" or 3/4" drip irrigation poly tubing.
1/4" barbed fittings are available in several configurations to give you the most flexibility in the installation and layout of 1/4" micro tubing. Use with a Hole Punch to attach to 1/2" or 3/4” solid drip irrigation tubing. No glue or lubricants are required.
When removing or repairing 1/4" barbed connections in 1/2" or 3/4" drip tubing, use a goof plug.
DD-C250 - Drip Irrigation 1/4" Barbed Connector.
Direct Drip 1/4" (250) Connector Barb X Barb. This is one of the common fittings found in drip irrigation. This fitting is often punched through a solid drip line to create a connection for 1/4" micro tubing.
DD-T250 - Barbed Tee.
Direct Drip 1/4" (250) Tee Barb x Barb x Barb. A Tee Barbed Fitting can be punched into a 1/2" or 3/4" Solid Drip Hose and will create an outlet for 2 seperate 1/4" drip lines. Emitters can then be attached to both ends of the 1/4" tubing.
DD-L250 - 1/4" Barbed Elbow.
Direct Drip 1/4" (250) Elbow Barb x Barb. Turn corners on your Drip System easily with 1/4" barbed fittings.
DD-FCV250 - 1/4" Barbed In-line Flow Control Valve.
Direct Drip 1/4" (250) Flow Control Valve Barb x Barb. Used the FCV250 to shut off flow to no longer used Emitters in a Drip Irrigation System
DD-GP - Goof Plug - Dual End 1/4" & 1/8".
Direct Drip Dual End Goof Plug. NOTE: Always purchase Goof Plugs for your Dirp Irrigation System. Goof Plugs are used for correcting mistakes when installing a Drip System. They are also helpful when Drip Irrigation components need to be re-located for changes in plant locations. Goof Plugs can also be used to plug the end of a 1/4" drip hose.